Whoop 65mm frame

thingiverse

Print details: Infill: 0 Wall line number: 3 Generate Support: Yes Build plate adhesion: Brim with 2 lines - This also creates a good edge for the ducts and holds in place the support securely. Weight ~ 6.4 grams, slightly above average. To install the motors, position the top part of the motor halfway inside the holder and push it down as far as possible in this initial position. Then, carefully insert the bottom part of the motor. In some instances, the motor overheats and softens the PLA, causing the motor to spin out of control. To resolve this issue, a small amount of hot glue is applied at the end of the motor to secure it firmly against the support.