White LED-tape to jumper-wire CONNECTOR

prusaprinters

Use this connector to connect jumper wires to white LED strip lights.UseThe connector has two distinct sides, one with a flat slit and the other with a slit and two jumper wire entry cutouts.Note that LED strip lights may not be reversible. Ensure you are connecting the correct side to power. If you don't know which, just try it. If it doesn't work, turn it around and try again.Peel back paper on LED strip and insert into the flat slit side until it just emerges from the far side, with the sticky side away from the cutouts.Firmly and carefully insert jumper wires into their cutouts. They should be in firm contact with the copper pads on the LED strip.3D Printer applicationI used two connectors to connect two 12V strips in series to create a 24V unit. I connected these to the 24V supply of my 3D printer. With a total of only 6 LEDs, this is a negligible draw on the power supply. I mounted these near/on my webcam to provide print lighting for remotely monitoring prints when the room is dimly lit.