White House Ornament

thingiverse

I submitted this creation for the Instructables 3D Printed Ornament Design Challenge, and you can find all other submissions at http://www.instructables.com/contest/ornamentdesignchallenge/. If you enjoy it, a vote would be greatly appreciated! I'm WoodmanXI and have given my seal of approval. Thanks so much! Instructions Set your layer height to 0.2mm. Ensure fill density is 100%. Print at a speed of 80mm/s. External perimeters, top and bottom layers: slow down to 70% speed. Maintain a bridging speed of 40mm/s. Refrain from using support material altogether. Heat the extruder to 250c for the first layer and then settle at 240c. Keep the bed temperature steady at 115c. Printing will take about one hour, thirteen minutes, and thirty-four seconds. I used a reliable 3mm filament that measured out to be approximately 5577mm (35.6 cubic centimeters).