Wheeler FAT Wrench Holder Pegboard

prusaprinters

Since no one else has gotten around to this I did. It's just a holder for the Wheeler FAT wrench on pegboard. It's a close fit but the tool sits loose in it. I did goof the math and there is a spot for one more bit than the set comes with, so nothing I'm going to worry about removing. And the base of the tool has nothing preventing it from being slipped out that way. If I find that it is an issue I'll do up another version with a nub on the base just to give it something to hold it in but I don't think it will be necessary. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: Doesn't Matter Supports: Yes Resolution: .2 Infill: 15% cubic Filament: spool3D PLA Notes: I did use support blockers on the hex key slots as they are small enough no support was necessary, they are a close fit Category: Tool Holders & Boxes