wheelbarrow handle

thingiverse

I'm adding a new simple project - maybe it will be useful to someone. These are wheelbarrow handles, which are made of a pipe with an outer diameter of 32-32.5 mm. I also used two inner lines, about 0.5 mm thick each, to stabilize and block the overlay when applied. Below I present the parameters on which I printed but everyone can use different ones if they think it is right. Layer 0.16 Infil 25% Speed 60 / s Material PLA CURA slicer reported bugs in the project, but don't worry if your slicer also reports it. Prints fine despite this.