Werkzeug Griff

thingiverse

Sometimes, setting up the supports just doesn't work out and the underside looks pretty disappointing as a result. But often, with a little bit of tinkering, it can be fixed again. I then take a rod, heat it up at one end, and use it to apply pieces of support material to the faulty areas. I spread them evenly and use this to repair those areas. I don't really like holding a hot piece of iron or steel in my hands, so I made a handle with Volcano printed on it, which becomes quite heat-resistant after being treated in the oven. To complete the part, I used a 4mm round rod and pressed it into place while it was still warm. BUT BE CAREFUL: When pressing the round rod into place, don't heat it up too much and press the rod into place before treating it in the oven. You can support our club with a small donation if you'd like. This is a project by and for Club MachWas. Please send donations to: Club MachWas Hauptstrasse 122 4252 Bärschwil Switzerland IBAN CH15 8009 7000 0067 4768 7 PC: 40-12286-8 Raiffeisenbank Laufental - Thierstein or PayPal at https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=BKMD6QV2LQ844&source=url