WELS logo

thingiverse

Iframe src="//giphy.com/embed/l2YSqecXZIIBSbAgE" width="480" height="270" frameborder="0" class="giphy-embed" allowfullscreen="allowfullscreen"\nThis concept has been on my mind for months, without sketching anything I had a clear vision of what I wanted. All it took was a few hours to design it in Tinkercad, but getting the tolerances right proved tricky. Still, it turned out really nice and would make a wonderful gift for any WELS enthusiast. If you're not familiar with WELS, it stands for Wisconsin Evangelical Lutheran Synod - check them out at http://www.wels.net\nPrinting instructions: This print is a breeze. The only part that requires supports is the red piece. Make sure to avoid platform adhesion on all parts as it would make assembly impossible. I kept this design small to accommodate smaller print beds, but scaling it up should work fine. However, please note that this model was not designed for downsizing and tight tolerances might be a challenge for most printers.\nGuidelines for using this logo are available in the attached PDF - check it out before using it for advertising or any other purpose.\nThis design was crafted with Tinkercad. Feel free to edit it online at https://www.tinkercad.com/things/ctoaUm3jHP8