Weighted Souvenir Coin

prusaprinters

<p>Print your personalized souvenir coin (4cm diameter) with a ½" washer inside for additional weight! I included a “blank” coin that you may personalize with your own designs (if you don't want my astronaut logos or just really like smooth coins).</p><p>WASHER: ½" with OD 34.91mm (1.37") ID 14.45mm (0.56")</p><p>I printed both halves at the same time using ColorFabb bronze-fill PLA, 0.15mm layers with supports. Enable ironing on all top layers to smooth the finish and reduce the sanding required.</p><p>Once printed, remove support material and place the washer inside. Use super glue to secure the coin's inset face, hiding the washer inside.&nbsp;</p><p>I finished the bronze-filled PLA sanding <i>by hand</i> with progressively finer modeling sand paper. Do not use a Dremel or polishing wheel – the PLA will get too hot and start to melt.&nbsp;</p>