Weeping Angel Tree Topper

thingiverse

I reworked this from the original using Meshmixer, so it could serve as a tree topper. I advise using .2 layers, though it was printed at .28 layers with no infill, three top layers, five bottom layers and four perimeters (utilizing a .4 nozzle). A hole was then drilled into the bottom using a hole saw bit (which will be further drilled to hold LED's). *TIP: When drilling the hole, exercise caution! Once the guide bit breaks through, you can reverse the drill to gently cut the hole through the plastic No supports were needed! CAUTION: Wives and small children may not appreciate this!