Waveshare Pi Compute Module 4 (CM4) PoE Board CASE

thingiverse

This is a case I designed from scratch around the 3D model file for the Waveshare Compute Module 4 PoE IO Board. I designed the Lid of this case to hold a 60mm fan directly above the CM4 with a 15mm tall heatsink on top of the CM4. I printed this case out just fine on my Ender 3 Pro and it fits the board perfectly. I did NOT create any openings in the case for the DSI or CSI connectors, or for the MicroSD Card slot, as I do not need to use those connections. I did however create one extra hole on the back left corner for a U.FL (IPEX) to RP-SMA antenna connector. I have included the Fusion 360 file (*.f3d) so you are free to make modifications to this case as you see fit. The Lid could still use some work, as I have not created any way for it to stay securely attached to the case yet. Right now, it just sort of friction fits into place. Note: The Waveshare Compute Module 4 PoE IO Board comes equipped with four brass standoffs on the bottom of the board. This case was designed to fit the board with those standoffs attached. If you remove those standoffs, the board will sit too low inside the case and the openings for all the ports will not line up properly.