Waveshare 18396 5" DSI LCD 4040 Mount

thingiverse

This is a remix of thing:4606326 and thing:4838853 I wanted a display-only mount for my Anycubic Vyper. The original case was made for the BTT PITFT50 and did not fit in respect to the mounting holes and the display cutout. This is the used LCD: https://www.waveshare.com/5inch-dsi-lcd.htm I ordered it from welectron.com The base was defeatured in FreeCAD, new mounting holes and a cutout for the DSI cable was made. Otherwise the base is unchanged. The top part was resesigned from scratch. I'm not completely happy with the clamps, they work but are not perfect. The display cutout fits very well. The mount is also a complete resedign based on thing:4838853 but without the hammers. I wanted to use hammer nuts as always and don't understand what these printed hammers should be good for. You can't fix the part properly this way. Also I had to move the display more to the right as it almost collided with the bed. Anyway it was impossible to use the display when the bed was in the higher y-regions. The tolerances between top and base are tight! If your printer tends to over extrusion fix that or scale the top part a little bit. I printed with black PLA from Material4Print, the top is LH 0,1mm the base and the mount 0,2mm.