Watersaver / flow restrictor - BSP 3/4" - Standard size

thingiverse

Print out this design, attach it to your faucet and start saving money on water bills while doing your part for the environment. This innovative solution was created from scratch with a second iteration that proved to be perfect right off the bat. I've added a small rubber gasket inside to ensure a watertight seal, but I'm confident that a bit of Teflon tape would work just as well without it. I printed this design at 45% infill using PETG and was blown away by its performance. To get the best results, print the threads facing downwards and only add supports to the middle section - you can easily remove them afterwards if needed. The internal components print beautifully without any extra support.