Waterlevel sensor mount with cableguide

prusaprinters

I need to fill up a water container once in a while and want to stop the water flow, when the water has reached a certain level.For this I created this mount. Just screw in a standard water level sensor, guide the cables through the cable channel and connect it to your water level controller. Optionally, the cable can be zip-tied to the mount (see picture).The mount has brackets to hang the mount into your water container. I added two brackets to choose between two different water levels depending on how much water I need.Print instructions: ideally print with PETG, because the bracket might get in contact with waterprinting with 0,3mm layer height is sufficientAdd support to the gap, where the sensor will be attached (see picture)