Water Spacer

prusaprinters

<p>This spacer allows you to assemble the Fountain to the Pump without the need for a plastic hose. &nbsp;Gently press the pipe spacer onto the Water Pump, &nbsp;then push it into the Plateau Fountain outer curved edge to the top, inner curved edge to the bottom. Gently lower complete assembly into the area you want. &nbsp;</p><p>This is for the “ Deep Base ” Remix only</p><p>The water pump is the same as used in the original Modular Desktop Fountain.&nbsp;</p><p>You may need to sand a bit to fit if your printer isn't dead nuts on Calibration. It should be just able to slip on the pump spigot and into the bottom of the Fountain.&nbsp;</p>