water pump drill powered

thingiverse

Water Pump Project This water pump is incredibly easy to print, requiring almost no support. I used M8 screws for the shaft and drill mounting, which worked perfectly. The 550-watt drill I used runs at an impressive 1,000 rpm at maximum speed. I estimate that the pressure was around 1-2 bar. To achieve a tight seal on the pump cover, I employed foam tape, although gluing it together might be even better, as some pressure was lost between the cover and the pump housing. When assembling the impeller, make sure to maintain approximately 2mm of space between its top and bottom. I'm already planning my next project: a water pump designed for cordless drills. If you're interested in this project, be sure to subscribe to my channel. Additionally, if there's enough interest, I can create a version suitable for stationary motors.