water level controller hose clip for Fluval Flex filter compartment

cults3d

After I bought a Fluval Flex 35l/9g (okay... mainly because it looked nice) I quickly noticed some flaws and / or opportunities to tinker :-) So I started to redesign and add some things. This is Part 5 of the project. The whole project will cover cooling, heating, light control, water refill (and whatever idea I will have in addition) using an ESP micro controller and without any destructive modifications at the tank hardware. This is a holder for a hose from an automatic water level controller like Tunze Osmolator nano (the one I use) or any other using a 6mm/0.25in hose Print the parts and put the flex_clip over the hose. Fix it with the flex_screw_long through both holes and to the upper side of the holder. then put the flex_screw_short into the other tapped hole but don't screw it in too far. place the holder on the dividing wall between the intake chamber and the filter chamber and lock it into position by tightening the short screw. The hose easily fits through the gap at the middle of the lid. The models should be printed in the orientation of the stls All models can be printed without support Print: 1x flex_screw_short 1x flex_screw_long 1x flex_clip 1x flex_holder Use PETG, PA or any other food safe material and water the model for at least 24h before inserting it into the tank. [UPDATE 14/JUN/2019] fixed the orientation of the screws published project parts so far: + Fluval Flex Cooling Fan Adapter 40mm https://www.thingiverse.com/thing:3640543 + Fluval Flex Cooling Fan Adapter 80mm https://www.thingiverse.com/thing:3671625 + Fluval Flex Filter Mod https://www.thingiverse.com/thing:3639353 + Suction cup temperature sensor mount for DS18x20 https://www.thingiverse.com/thing:3640844 + water level controller hose clip for Fluval Flex filter compartment https://www.thingiverse.com/thing:3675744 + Fluval Flex Intake Pre-Filter / Baby-Safe https://www.thingiverse.com/thing:3730658