Water Jet Drive 64 mm Version 2

pinshape

This is new Water Jet Drive 64 mm  for electric Surfboard: https://www.youtube.com/watch?v=69YW7y_0W64 ************************************************************************************************************************************* My used electronics (do not use it): - https://hobbyking.com/ru_ru/turnigy-rotomax-1-20-brushless-outrunner-motor.html - https://hobbyking.com/ru_ru/hobbyking-yep-80a-hv-4-12s-brushless-speed-controller-opto.html - https://hobbyking.com/ru_ru/turnigy-battery-5000mah-4s-25c-lipo-pack-xt-90.html (two batteries 4s x 2 = 8s) I recommend using a 300 - 450 kv motor. Do not buy my rotomax 1.20, its 280 kv at 8s (8400 rpm) was not enough. Therefore, you should have 10000-15000 rpm. Then you will rush like a rocket. ************************************************************************************************************************************** The model is very very durable, you can’t break it with your hands, I tried to compress it in different ways, but sintering is so good at pla that it is impossible. This project was created in Fusion 360 and printed with my Artillery Sidewinder x1   My print settings: - Black PLA - 220* nozzle; - 60* bed; - 65 mm/s - 100% fill ************************************************************************************************************************************* In this table you can view a list of parts ( Shaft, bearings, screws, nuts....) that will be needed for production. https://docs.google.com/spread... ************************************************************************************************************************************* If you have questions, you can write to my mail:    davydoff2202@gmail.com If you want to buy cheaper, then I can sell you for $ 20, because the site takes a percentage. Write to the mail and I'll drop the files **************************************************************************************************************************************