water holder for Janoel 12 Incubator

thingiverse

This container enhances the humidity in the Janoel 12 incubator by approximately 15-20% through its water-holding capabilities. Strategically placed holes at the bottom of the divider enable effortless water circulation between both sides, ensuring a consistent level of moisture. With the lid securely fastened on one side, refilling is only necessary every other day. Initially, simply adding water to the incubator's bottom caused excessive humidity, prompting the need for a smaller container that could maintain optimal levels without frequent replenishment. Instructions: Fill the container with warm water and secure the lid on your preferred side. This container fits neatly on the top tray between the egg turning tray and the wall (located near the thermometer). If printed in clear filament, you can clearly observe the water level through the incubator's side panel. To enhance visibility, a small piece of craft foam was added to float on the closed side, making it easier to monitor the water level. This design was created using Tinkercad and can be edited online at https://www.tinkercad.com/things/llHfrJycAiQ.