Water filter for rain barrel

thingiverse

Filter for a rain barrel, approximately 7 cm wide and 6.5 cm high in size. It fits perfectly on a rain barrel with a pipe that requires an M27 nut. A portion of a pantyhose was used to create this filter. A knot is tied below it and the other end is folded inward, secured by the lid of the filter. The filter was printed with support for all vertical holes, but this may not be necessary and can be bridged instead. Just mounted it, so I don't have a lot of experience yet. Cleaning the filter from time to time is essential. In your slicer, rotate the lid 180 degrees and both nuts 90 degrees.