Water dispenser button for Samsung Refrigerator

thingiverse

This is a stop gap measure for the water dispenser that is inside the refrigerator on a Samsung french door model fridge. You can buy one of these doodads (plate, lever and button cover) for less than $20, but if you're in a pinch and don't care about that rubber button cover, this will only cost you a little filament and some time. It prints in about 1.5 hours. To install it, you'll need to remove the button cover to hang the lever at the top of the oval hole. I didn't have the actual lever to copy so this will need to be revised because this (v2.2) design doesn't fit under the rubber cover. The button plate broke where the lever hangs and I just glued a wire to be able to hang this lever. It's not meant to be a permanent fix (unless you don't care about that rubber button).