Watch Display stand

thingiverse

I designed this watch display stand specifically to showcase my 3 watches. It can hold up to 3 timepieces at once. The prints are remarkably straightforward and don't require any supports or rafts, making them a breeze to produce. In total, there are 5 components, but only 3 of these need to be printed: the stand v1, rod v2 (smaller edition), and 3x watch cushions v2. Important Note: When assembling this display stand, please pay close attention to two critical details to ensure a seamless experience. Firstly, when attaching the watch cushions, take note that the rod passing through them is slightly loose. This will cause the cushions to rotate under the weight of the watches. To resolve this issue, simply wrap one layer of tape (any type will do; I used black duck tape) underneath where the cushion sits, making it tighter and a better fit. Secondly, when attaching the rod to the stand, ensure that the little triangle tab on one end is aligned with the hole featuring the cutout. When securing the cushions, align this tab with the corresponding cutout in each cushion. With the rod attached to the stand, the triangle tab should be situated inside the cutout, not outside, to prevent the rod from rotating unnecessarily.