Warrant Officers - Bars/Blocks (US Army)

prusaprinters

<p>Can't forget about my Warrant Officers in the US Army!</p><p>If using PLA, I recommend resizing the blocks to 98.5% so it can fit snug/tight without using glue. &nbsp;In my opinion, it just looks better to insert it tightly than to glue it in.</p><p>To insert each block inside the space on its designated bar, you'll need a rubber hammer and a very small (watch type) hammer with a wide flat-surfaced center punch. &nbsp;The rubber hammer for the center and the small hammer to seat it properly at each corner. &nbsp;It doesn't take long at all if done right.</p><p>Using a SLA/LCD (Resin) printer for this design is highly recommended because it comes out smoother and the blocks inserts nicely without using any hammers or tools.</p>