Warmachine/Hordes Objective Marker

thingiverse

This is a Warmachine/Hordes objective marker for use in Steamroller scenarios that utilize objectives. It comes with two printing options: 1. The entire model: Objective3 - Whole.stl. Be prepared to achieve good support and overhang capability. I envision this mostly for display, but it's likely possible to print from it. 2. A set of components that can be printed almost flat - there is a bit of overhang on the inner and outer polar rings, where the slot is angled to fit, but that's it. It's best printed in sections and assembled from the inside out: 1. Slot the disc into the inner polar ring at a 30-degree angle (follow the notches). Don't glue until you've slotted it into the outer polar ring and confirmed which side is up. 2. Slot the inner polar ring with disc into the outer polar ring so that it's at a 30-degree angle from the disc and 60 degrees from the inner polar ring (follow the notches). 3. Slot the outer polar ring, inner polar ring, and disc into the equatorial ring following the notches - the outer polar ring should slot into the deepest notch, the inner polar ring into the medium-length notch, and the disc into the most shallow notch in the center. 4. Slot the outer polar ring into the pyramid via the peg at the bottom. If you don't glue the equatorial ring (it should fit pretty snugly anyway), you can remove it and re-slot the disc in the middle with something else. For my prototype, I only glued the inner and outer polar rings together - everything else just fitted when I put the equatorial ring on. This is a work-in-progress, and my plan is to add some text or runes to various pieces to give it some extra flair. The inner disc is intentionally 2.75mm rather than 3mm like the rest, so that it can be done in lasered acrylic rather than 3D for an added cool look.