Warco WM250V Lathe Dial indicator holder

prusaprinters

It clamps onto the bed of the lathe and screws onto the tab on the back of a dial indicator.The back of the indicator plunger fouls the headstock when the carriage is close to it but with a 25mm indicator, it only reduces the carriage travel by 4.5mm.Required hardware:3mm brass rod: 16-18mm long (for pivot)30mm M4 bolt hexagon headM4 nut16mm M6 boltM6 half nutPrintingI recommend PETG. There are 3 parts to print. The brass rod can be tapped into the hinge with a hammer.The Top and Arm should be printed on their sides and the Thumb Screw with the hex down.Supports required on the hinge and in the hex of the thumb screw.