WANHAO Duplicator i3 v2 MicroSd to SD card Adaptor Holder

thingiverse

I purchased a MicroSD to standard SD card adapter from Amazon.ca (ASIN: B01CY0VO3U) because I disliked using small cards that could easily fall into the cracks of my workbench. However, I soon encountered two problems. The first challenge was securing and locating the adapter within the control box. The second issue was that the MicroSD end cable stuck out of the box, putting it at risk of breaking accidentally. To address these issues, I decided to design a bracket that would hold the adapter while also protecting its fragile connector. The bracket's design allowed it to snap into four venting holes, two on each side. When printing the part, be cautious and orient it so your slicer aligns the internal support in lengthwise direction. If not, you may end up with difficult-to-remove internal supports. Printer Settings: WANHAO Duplicator i3 v2 Rafts: Doesn't Matter Supports: Yes Resolution: .200 Infill: 20