Wanhao Duplicator 6-Maker Ultimate Hole Plugs

thingiverse

Update 11/17/2019: After much contemplation, I finally spotted the servo coupling hanging loose beneath, waiting for some stray filament to wrap itself around it. I added the Coupling.stl file which can be printed without support by printing the front side facing down at a .2 layer height and 100% infill. Cover up the holes under your build plate to prevent pesky chunks of filament and small items from escaping where they shouldn't go. Whether you're working with tiny parts that break off easily or dealing with delicate electronics, keeping unwanted debris out is crucial. Obviously print these flat with the bottom side facing up. I used PLA at 210C/50C, 80mm/sec, .2 layer height and 50% infill, but feel free to use 20% fill too - it'll save you a few minutes. You'll need one Back center plug, three Corner-3 plugs and one Coupler cover. The Corner-tiny is there for perfectionists like myself who want that last corner sealed tight as well. Also, be sure to check out my Wanhao D6/Monoprice Ultimate wire retainer if you haven't already - it's a lifesaver: https://www.thingiverse.com/thing:4051105