Wanhao 4 Z-Axis_Brace

thingiverse

I found only one z-axis brace for the Wanhao Duplicator 4, however it was only for the 4S.This is partially a remix of Delukart's Z-axiz-brace. Credit where credit is due, go there if you want a brace for the 4S.I adjusted the bushing to fit my Z-axis rod. You may need to do this too.I used a little bit of Delukart's Brace, and made this truly ugly thing, but it works.You will need to drill through the top frame of your machine to secure the brace. Two bolts, two nuts, use common sense here.You need to put the bushing into the bottom of the brace,and wiggle it onto the top of the z-axis rod. It should snugly fit into place.Should stop the z-axis wobble.Note: If you are still getting issues, then check your x-axis, and y-axis rods.