WAND COLLECTION DISPLAY

cults3d

This is my Wand Holder design for the ultimate wand collection. Get it with an unbeatable price tag! Model crafted by me, and you'll be amazed at how easy it is to assemble - no glue required whatsoever. The models are cleverly designed as puzzle pieces that fit together seamlessly. Modeling time was a mere 2 hours, and the total polygon count is remarkably low at just 10,000. This design is ready for printing straight away. Here are the Creality CR-10 printer settings you'll need: Print "HOLDER PARTS" with a layer thickness of 0.15mm (150 microns) and an infill percentage of 30%. Set your bed to 60 degrees Celsius and your nozzle to 200 degrees Celsius - remember, this may vary depending on the filament you're using. Printing time for each holder is approximately 3 hours. Print "CONNECT PART" with a layer thickness of 0.15mm (150 microns) and an infill percentage of 30%. Set your bed to 60 degrees Celsius and your nozzle to 200 degrees Celsius - again, this may vary depending on the filament you're using. Printing time for each connect part is also approximately 3 hours. Finally, print "WAND COLLECTION TEXT PART" with a layer thickness of 0.1mm (100 microns) and an infill percentage of 80%. Don't forget to turn on support and set it up for 50 degrees Celsius. Set your bed to 60 degrees Celsius and your nozzle to 200 degrees Celsius - yes, it may vary depending on the filament you're using. Printing time is approximately 1.5 hours. The total printing time? A mere 10 hours!