Wall Snowboard holder

prusaprinters

<p>The two Holders make it minimal and quick to take the snowboard and put it to rest to furnish your home with style.</p><p>Printed using Prusament Petg Black and Orange Petg</p><p>Layer Height: 0.15 Quality</p><p>No Supports!</p><p>100% Infill to be strong!</p><p>Dimensions: 31mm highter x 30mm diameter.</p><p>Required: ​​Drill, 8mm bit, pliers, 8mm wall fischer plugs with double threaded screw (in the wall 40mm, outside wall 30mm) 2x m8 nuts.</p><p>How does it work?</p><p>When you insert the snowboard between the two holders with the V-guides and let it go down, the board will automatically lock and lock itself in the widest part.</p><p>To remove it, just pull it up and let it come out again from the central part.</p><p>How to calculate the distance for the holes in the wall?</p><p>Measure the width of your board in the middle (thinnest) part and add 30mm. Ground clearance is up to you.</p><p>Drill the wall with the 8mm bit and insert the fisher plugs.</p><p>Screw the threaded pin firmly into the wall until it stops. Help yourself with pliers.</p><p>Insert the M8 nuts in the holders and screw them on the threaded pins that come out of the wall, helping you if necessary with the hex key that you can print.</p><p>Once the pins are tight, insert the caps to cover the nuts and give a touch of design to your new snowboard holder.</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p><p>&nbsp;</p>