Wall mounted pen holder

prusaprinters

<p>A pen holder for screwing to a wall</p> <p>read the print instructions as the STL on its own is useless without a few tweaks to the profiles</p> <p>Look at the other pen holder that i have uploaded</p> <p><a href="https://www.prusaprinters.org/prints/1363-honeycomb-pen-holder">https://www.prusaprinters.org/prints/1363-honeycomb-pen-holder</a></p> <h3>Print instructions</h3><p>The STL is just a solid with two screw holes in it</p> <p>To turn it into a penholder you need to turn off the top layers and have a hex infill set to 6%</p> <p>If you do this then it works but the screw holes end up looking a wee bit off</p> <p>So if you use the 3mf file you will see i have added two off modifiers which turn on the top layers and increase the infill just at the ends</p> <p>This gives you a better finish on the screw holes</p>