Wall mounted drill bit holder

prusaprinters

<figure class="image"><img src="https://media.prusaprinters.org/media/prints/129899/rich_content/936a980f-d225-4b54-9a96-b4f70c0f2137/drill-bit-holder-final.jpeg#%7B%22uuid%22%3A%2215af4f81-f010-4b05-abf4-e3f6f1b5077d%22%2C%22w%22%3A640%2C%22h%22%3A598%7D"></figure><p>A compact, wall mounted drill bit holder for bits sized 1/16" through 1/2" in 1/64" increments. This holder measures 8" in length and holds bits at a 30º angle quick and easy access. For smaller bit sizes (1/16" through 3/16"), two slots are available so you can keep a spare bit handy in case one breaks. Behind the bits, a recessed tray provides room for storing pens, pencils, or even additional bits that you are using during a project.</p><p>Replacement bit sets that fill all available slots are available on Amazon: <a href="https://amzn.to/34daPdn">https://amzn.to/34daPdn</a></p><p>Designed to be mounted to a wall with two screws, but could be adapted to mount with adhesive (like Command Strips) or magnets.</p><h4>Print Instructions</h4><p>Print the single 3MF/STL file with the large, flat side on the print bed.</p><p>No supports necessary.</p><p>Printed in PLA with 0.25mm layer height and 25% infill density. Printed with skirt, no brim or raft. Try using adaptive infill strategies to further reduce required material.</p><p>After printing, generously paint over the recessed size labels and then wipe away the excess paint on the surface. The paint should get “stuck” in the labels while the surface wipes clean, creating higher contrast and easy readability. (Tip: When wiping paint away, don't use a paper towel or small amounts of paper will get stuck in the labels.)</p><p>As shown, sliced with IdeaMaker and printed on Raise3D E2 with Prusament PLA.</p><p>NOTE: It is recommended to use the 3MF file to maintain dimensional accuracy for all the bit holding slots.</p><h4><strong>Need Help? Feedback?</strong></h4><p>If you have any questions or trouble with this print, or if you have suggestions for additional revisions, <a href="https://www.prusaprinters.org/messenger/new/160843">send me a message</a>. Happy printing.</p><p>And while you're at it, <a href="https://www.prusaprinters.org/social/160843-toddanglin/about">help yourself to my other prints</a>.&nbsp;</p>