Wall Mounted Cable Wrap

thingiverse

Designed to conquer cable chaos, eliminate the spaghetti mess of cables on workbenches, in cabling closets, along cable runs, making it easier to clean up and manage the area. Created using freeCAD software. I deliberately ran excess cable during my cable installation project, and I strongly dislike using cable ties. Adding or removing cables from a cable tie setup is excessively tedious in my opinion. In the past, I would wrap everything around a screw on a nail in the wall, securing it with a zip tie to form a loop. However, I wanted to see if we could achieve this without relying on that method. Due to the varying lengths of my cable run, I had to print out an additional unit to ensure even distribution when plugging into the switch. For future network expansions, I may need to print more units, but avoiding zip ties will be a welcome relief. This design also allows for quick disconnection and reconnection if a new network standard becomes available.