Wall Mount Multiple Filament Spool Holder

thingiverse

Here is another Wall Mount Filament Spool holder I designed. It utilizes a standard 1/2" aluminum tube, readily available at most local hardware stores for approximately 7-8 dollars per three-foot length of tubing. Each mount component boasts four screw holes to ensure secure mounting and adequate support for the weight of the filament. Although I haven't thoroughly tested its maximum capacity yet, with about 2.25 kilograms worth of filament in place, it exhibits no signs of strain and appears capable of holding significantly more (printed at a 65% infill rate). If necessary, an additional third mount could be printed and attached to the middle section of the rod for added support against weight. The 1/2" tube fits fairly snugly, potentially requiring a bit of force to initiate insertion, but should then slide smoothly into place afterwards. Please share your experiences with this design and if any issues arise, kindly comment below!