Wall Mount for the SUNLU S1 Dryer Box

thingiverse

This is a wall mount for the SUNLU S1 Dryer box. It's been designed to fit on the Ender 3 laying flat. This design requires you to drill through the side of the filament box in 8 places to secure the mount to it, using the wall mount as a drill guide. In addition, 8 M5 screws/washers/nuts are also required. An alternative would be to epoxy it, but I have not tested it and it sounds like a messy solution. x2 wall anchors are also required. I have put the holes in to 114mm pitch because of existing holes in my wall. Again, the wall mount can be used as a drill guide. Recommended steps are:Print the wall mountRemove the clear lid to work with the dryer-box a little easierTape the wall mount to the side of the boxDrill two holes and secure the wall mount to the box Remove the tapeDrill the rest of the holesRemove the wall mount from the dryer box, remove any swarf and clean up the holesSecure the wall mount back onto to the boxMount the assembly onto your wall using appropriate wall anchorsPlease note, this part will work on either side of the box, so It can work either on the left/right side of your printer. Also be mindful of the screw length as not to protrude too much into the box. There's plenty of space for a nut/washer, but I wouldn't go too long. Happy printing!