Wall Mount Bracket for Harbor Freight "Portable Storage Case"

prusaprinters

This is a wall mount bracket to hold these Harbor Freight "Portable Storage Cases" (item# 95807). The bracket has aslight downward angle so you can see inside a bit easier. These were designed so that each case could easily be lifted out and taken to a work area. Mounting tips: I used a drywall anchor to mount each bracket to the wall. This works, subject to the usual annoyances and limitations of drywall anchors. Update: After ~2 years the drywall anchors I used are starting to loosen up. If I did it again, I would mount some 1x3's into the studs, and then screw these brackets into those. Space the brackets 22cm (on center) If mounting multiple cases vertically like I did, I recommend spacing them 15cm to ensure you have enough room to remove them without hitting the bracket above. The "revised" STL incorporates some changes I made after printing the initial batch. Mainly the the screw hole is a bit smaller (since I changed what type of drywall anchors I used). Print Settings Rafts: No Supports: No Infill: 30% Category: Tool Holders & Boxes