Wall Dock for J1772 EV Charge Cable

thingiverse

I sought an uncomplicated dummy port for the J1772 EV charge cable, but consistently found elaborate recreations of all internal plug connections instead. I didn't need those because this is simply a holder for the cable when it's not in use. I deliberately avoided intricate internal designs that could result in a poor fit if individual connectors failed to mate properly due to design or print tolerances. The inside of this connector remains largely empty since nothing needs to be there. It merely features an internal channel at the bottom and the latch receiver at the top – all that's required for a snug fit. Designed with two vertically aligned screw holes, it can be securely mounted on a wall over a stud. Only minimal print supports are needed, consisting of a small section for the latch receiver at the very top. I hope this is useful to you and that you'll share your creations and feedback.