Walking Stick Holder

prusaprinters

<p>Unfortunately my mum has to use a walking stick to get around. However, my mum being my mum has seen an opportunity and turned them into a fashion accessory.</p> <p>I always visited and thought it was a shame all her different sticks were stacked in a corner. So after a couple of designs we created this wall holder for her sticks. This holder has so far been fine for holding all the sticks she currently has and we are yet to find one that's a problem.</p> <p>The holder itself comprises of two parts a section "B" that has the stick man on and screws to the wall and a section "A" that slides onto the other section to hold the stick. This helps to create that floating shelf effect.</p> <p>I have a range of designs for this I have just included three with this upload. If it proves popular I will add the others.</p> <p>As a note any "A" section will interface with any "B" section, so for one holder you just need to print one of each.</p> <h3>Print instructions</h3><p>The "A" section is printed with the large flat face down and the fillets are facing up. I have also been printing them with a larger layer thickness lower down then once the print gets to the height of the fillets reducing the layer thickness just to smooth that detail.</p> <p>The "B" sections should be printed with the stick-men on their back. Neither print should require supports.</p>