Wahl v2.0 Hair Clipper Attachments Size 1-9 3mm-28mm

thingiverse

Wahl Hair Clipper Attachments v2.0 Work-In-Progress Support for side walls has been added to mate seamlessly with Wahl Clippers. The redesigned Clip Mechanism boasts increased strength and reliability. Print angle has been optimized to minimize stringing and maximize structural integrity. Edit 6/4/17: To prevent interference with the clippers' bottom, the raised font is now beveled. Two notches have been cut into the release pad to ensure a secure fit within the clippers. Note: This project is still in development phase. Due to printing challenges, it may be necessary to trim the clip. Initially, two small supports were added to prevent the clip tab from printing mid-air. Current status: Test printing and fitting are underway, with adjustments made as needed to perfect the design.