Wahl Percussion Massager Tips

thingiverse

Wahl Deep Tissue Therapeutic Percussion Massager Tips This project came about because I have the Wahl percussion massager, which only came with two tips, and had lost the small round one. While searching online to purchase a replacement, I discovered other various kits of this same massager that included additional tips that I did not have. So that's what set me off to make my own. I did not make the large, flat surface tip (as I already had that), but also I did not attempt because I think it would be difficult to design/print when you consider the need for supports. Sorry if that's the one you need. I used Tinkercad to design, Hatchbox PLA for the print, and printed with 230/60 temps. I used 40% infill, but only 20% infill on one, they all seem to be pretty solid. Also, I designed all the tips with a 45-degree pyramid-shaped negative above the threads so there were no areas that needed supports, and therefore can all be printed with the threaded side down. 1. "Rounded Tip" - Blue 2. "Pointed Tip" - Orange 3. "Finger Tip Small" - Yellow 4. "Finger Tip Large" - Green The yellow tip (in the images) was actually a failed attempt of the Green one, but I included it in case you think you might use it.