WAGO 221-412 Stepper Motor Mount

thingiverse

UPDATE 8/8/2018 ------------------------ Added a 'B' version with wire strain relief tabs at the top. This mount can hold eight WAGO 221-412 blocks, each a two-conductor block. That's a total of four pairs of wires or conductors. I designed this mainly to fit onto the extruder stepper motor. With the four pairs of wires or conductors, it can handle the hotend thermistor, the hotend heater cartridge, the extruder fan, and the parts fan. This is a remix of my basic WAGO 221 mounts. There are six-millimeter by two-millimeter wide holes in the base of the mount for zip ties. The intent was to zip tie the mount to the extruder motor. This makes it easy and flexible with minimal filament required. And everyone has zip ties. The end with loops is the top, while the end without loops is the bottom. You can see from the picture that the zip tie goes up the bottom and out the back of the mount. It doesn't go out the top of the mount. The holes were positioned for stepper motors with 42.25 millimeter square cases. The spacing between the two middle rows of blocks is pretty tight. With my fat fingers, it's hard to open and close the levers. So I use a small flat-head screwdriver.