WacomOLED: Intuos 4 + iPad screen holder (DIY graphics tablet)

cults3d

Use this holder to build your own DIY Cintiq. The device is strapped onto a Wacom Intuos, and can be taken off. The pen tablet is not harmed. You will need: iPad 3 / 4 LCD iPad LCD HDMI driver board from aliexpress iPad glass some tape and some card paper Print the two sides standing up, and glue together with CA glue. There are some thin rectangular tabs protruding out of the inside of the two halves. These are for support material to grab onto, to provide stability. Turn on support material for Touching Buildplate. Cut the tabs off once the print is finished. Carefully remove the aluminium from your LCD. Sandwich the glass, the LCD, and optional card paper between the holder and the pen tablet surface. Use some tape where needed for stability. The card is only needed to keep the LCD in place when the device is off of the tablet. If you don't plan to repeatedly remove and reattach the device, you might not need the card. The LCD HDMI driver board screws onto the holder with M3 bolts. Use some stand-offs to rise it up a bit. Carefully snake the ribbon cable through the hole in the holder and place it under the board. Use some elastic straps to hold the device against the tablet. Calibrate your active screen area in the pen tablet settings. Build video: https://youtu.be/euFDoqKdiqo