VW Touareg Tailgate/Boot Latch Gear

pinshape

Replacement gear for VW Touareg tailgate/boot latch. Print Settings Printer: Frankenstein Rafts: Doesn't Matter Supports: Yes Resolution: 0.2mm Infill: 100% Notes: As this part is quite small and intricate, I recommend printing at a slower pace to prevent the hotend from pulling on the part at higher speeds. You may need to file some edges to ensure a smooth and clean fit, but it also depends on how well you can print the part. I achieved better results with overhangs using 0.2mm layer heights. PLA was the final result; I tried PETG, but it's quite soft compared to PLA and tends to get pulled around a bit. I recommend PLA or a nylon-based filament, although I haven't personally tried nylon, as the original part is made of nylon.