VW T3 syncro 16" Nabenkappe / Hub Cap

thingiverse

Special thanks to HanZ92, who initiated this project and designed it with me until it fit perfectly. If you're looking for this cap including the blank plate where the logo normally sits, check out his Remix on Thingiverse. English / English ====== Hub Cap for the VW T3 Syncro 16", part number 251 601 151 C. The cap was designed to match the original design closely. It fits very snugly under the wheel nut, so you need some force to put it in place. To make it easier and gentler on the cap, remove one bolt, place it underneath, and then tighten the bolt again. It was originally made for the 16" Syncro but should also fit the 14" Syncro (no guarantee!). If you try it with a 14" Syncro, please let me know if it works. It won't fit on the front axle of a 2WD because the fat cap is too big. It also won't work with Mefro-Number 43220 106, 6J x 16 H2 ET30 or Mefro-Number 43130 104, 6J x 15 H2 ET30 because these wheels use spherical bolts with a 12mm diameter, whereas the original bolts are 14mm. You might be able to enlarge the cap and test it, but I haven't tried that yet. Let me know if you made one!