Vudoo Magazine Feeding Fix

thingiverse

This little piece of plastic helps with feeding issues in some Vudoo rifles. Due to the draft angles needed to injection mold polymer magazines the polymer magazines are slightly smaller on the edges than the aluminum magazines. This is problematic in chassis that support the edge of the magazine rather than the center, such as the KRG Bravo. A small piece of plastic (3d printed or otherwise) can make up this difference and allow you to run both aluminum and polymer mags without issues. It also helps in any chassis where play in the mag well causes the rounds to nose dive. Since doing this I have not had feeding issues even when pushing on the front of the magazine. I used epoxy to hold them on, but super glue works as a more temporary solution for testing. I recommend printing in PLA and using tap hot water to soften the print and form it to the slight curve of the magazine.