vtech Kidizoom Battery cover

thingiverse

my grandchildren keep losing the battery covers off their vtech Kidizoom cameras. I saw a replacement for a different model on Thingiverse so I thought I should add my version as well. I opted to print this in 3 parts to keep it as clean as possible. The designers of the camera opted to create the end caps at a strange angle for some reason and both end caps are different. I chose to design a single piece to fit both ends. Because of the differences my ends don't match the opening exactly but cover the compartment well enough and clip in and hold. The kidizoom camera has a soft rubber type covering so I chose to print the outside surface of my design in TPU. The remaining 2 parts are printed in PETG. The fastener clip is screwed to the bottom piece using a small screw that I found in my junk drawer. I believe it is an M3x5mm I couldn't find any glue in my shop to bond the top and bottom together so I used some double sided cell phone tape that I had, instead. I printed my top covers with the kid's initials and have included those but have also included a blank top cover that can be used as is or could be altered as needed. Note: Sorry but the STLs are not oriented properly for viewing. Ensure you place them properly for printing. The clip gets printed on its side so it requires no supports. Obviously the top and bottom are printed with their flat sides down. The base has a small tab/extension at one end that will require a support but that should be the only part that needs it.