VSR-10 MB03 High Top Rail

thingiverse

An easy to print one piece high top rail (3mm higher than the original - I might also add a low version later) for VSR clone that follows the picatinny specifications as opposed to the original MB03 top rail weirdness, printed standing up with small supports for each of the rail slots, the holes perfectly line up with my MB03, I use the original rails screws, might or might not work on a original VSR - check the hole distances my MB03 hole distances starting from the back are 15mm - 91.8mm - 22mm I used a cheap PLA with high wall count for added strength (5 perimeters 0.2mm layer height and 0.45mm width with 50% line infill) - might be an overkill but the part is light (25g)