VS4-10 ESC mount (Mamba X)

thingiverse

This is a Mamba X ESC mount for the Vanquish VS4-10 pro though it may work on the origin limited too. This can work with or without the aluminum top plate that's installed on top of the plastic slider trays. This mounts on the Driver side. The motor wires are close to the driveshaft so ensure they are routed away from the driveshaft or short enough that they stay away from it. There are 2 different versions one is meant for those who have the cooling fan removed (Electronics tray Mamba X V1). The other is for those using the cooling fan (Electronics tray Mamba X with fan version) I have checked the measurements and Im confident this will work and fit under the stock boby but I have not printed or tested this version. I've included a spacer that goes under this mount to hold the front inner fender tight. not required but it will help keep the inner fender from rattling around. Also included are inner fender hold downs for the rear and other side, all the same part. These are only needed when you omit the aluminum plates which would have held the inner fenders in place. You will need 3 flat/tapered head m3's, length depends on if the aluminum plate is used or not, 8mm without the plate and likely 10-12mm with it. If all you have is a button head screws they will work too. Remove the cooling fan and retain the decorative plate with the X. Using the fan mount holes (with the decorative plate in between the ESC and the mount) fasten it with some 8-10mm M3's (4) If using the version with the fan you will need four 15mm M3's to mount the ESC.