VS4-10 Body clip holder

thingiverse

This piece replaces the inspection cover on the transmission with a body clip mount, making it much easier not to lose them. You will need to find the rod that runs through this piece - the smaller it is, the easier it will be to clip the body pin on. I found a rod with a 1.2mm diameter, which made it simple to clip the body pin in place. To accommodate different rods, I undersized the holes so they can be drilled to fit the one you may find. A m3 set screw, approximately 2-3mm long, is required to lock the rod in place. The rod is slid into position and secured with the set screw, which holds it firmly in place. I left my rod a bit longer than necessary, then cut it after installation. The space surrounding these clips can be quite tight, making them difficult to grab when they are clipped on. To make this process easier, I alternate the clips so that they are more accessible.