-[VRMan3D]-ScorpTail-iFlight-A

thingiverse

This is an incredibly useful (and rather stylish, if I do say so myself) turtle mode accessory for brushless drones. Drones with bottom slung batteries often flip over on landing, and this will safeguard your VTx antenna while ensuring success in crash flip/turtle mode. You'll usually land in the same inverted position (predictability is key for quick flips), keeping your rear props off the ground to facilitate a seamless flip back over. I experimented with 15 different designs - shark fins, hornet stingers, and more - but this one prints exceptionally well in TPU without support structures. To prevent the print head from retracting, I added a thin sheet (easily removable) for additional support at the top, allowing for unobstructed printing. This design not only prints flawlessly but also works remarkably well. Its lightweight construction and clever carrying handle make it a super handy addition to your quadcopter. Best regards, -[VRMan3D]-