VR80 VR-80 Mag Well

thingiverse

RIA VR-80 Mag Well So...there's not much out there for the RIA VR-80, when it comes to Mag Wells. There's maybe three available, two are 3D Printed for $29.95 and $49.95 and the 3rd one is a two piece moulded version at $39.95. It's nice lookin', but "out of stock". SO....I made my own. If you have access to a 3D Printer you can download this STL file (three versions) and make your own. One has preset insets (of my own design), another is plain and the 3rd one has enlarged AR relief images on the Left & Right sides. I'd suggest a flat black PLA or PETG. If you want to customize yours, I'd suggest printing up some water-slide decals to add into the blank insets. Use the "white backed" paper and be sure to clear-coat those decals before soaking them, or the ink from your ink-jet printer WILL RUN. Of the 3 (purchased) versions mentioned above, 2 have screws and nuts or small set-screws to hold them in place, the other has a "tab". My version DOES NOT. Screws are not needed, compression holds this Mag Well in place and recoil will not affect the fit. It just slides on and stays put. Beware...this is an 8-1/2 hour print job and... This Mag Well will NOT fit the VR-60...sorry folks. Best I could do.